IOptron 8602 Uživatelský manuál stáhnout pdf

Quick Start Guide

SmartStar

A Series Systems

(8600, 8602, 8603, and 8604)

Step 1. Preparing the Tripod

1. Extend tripod legs to full

extension.

2. Slide tray on bottom of shaft

(#7). Then screw on round

black knob (#9).

Step 2. Attaching the Mount

1. Raise wedge plate on the tripod by turning two tilt

locks (12);

2. Attach mount to wedge plate using supplied azimuth

lock screw (10).

3. lower wedge plate to it’s lowest position by turning the

upper tilt lock upward while lightly push the mount

down. Secure the mount by tightening the lower lock.

Step 3a. Installing Batteries

Note: you may use 8 AA batteries (Step 3) or the AC adaptor

(Step 5) to operate the mount.

Pull the batteries compartment cover (shown) open.

Gently pull the batteries holder (shown next) out of the

compartment to avoid breaking the attached wires.

Step 3b.

Insert 8 AA batteries

(not included) in the holder. Refer to the

diagram on the holder to orient the batteries properly. Replace

the holder back into the battery compartment and replace the

lid.

For reference: the battery pack fits in with wires on the bottom

right

(See arrow in photo). Use only fresh batteries. Using/mixing

old or low batteries may cause error messages.

Step 4. Attaching Telescope

Attach telescope to mount using dovetail lock knob (#2).

(Picture shows 80mm refractor. However all scopes will attach in

the same manner.)

#2 knob

1 2 3 4

Quick Start Guide 1
Diagonal 4

Shrnutí obsahu

Strany 1 - Quick Start Guide

Strany 2

Strany 3

Strany 4 - Diagonal

Komentáře k této Příručce

Žádné komentáře

IOptron 8602 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Dalekohledy IOptron 8602. iOptron 8602 User's Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Dalekohledy IOptron 8602